Real issue:
if you set joint rotator range to very high values (10E+100 for example), your part properties tool stop to showing up on every part on every craft. Fixes with designer reload.
Possible issues:
- You can't set rotator range higher then 180 degrees.
- You can't set rotator speed higher then 100%, even thought it shows value wich being set in xml, rotation speed still can't be faster then 100%.

Link to the privat video report

Bug Done Found in 0.6.6.1 Fixed in 0.6.7.2
Sandbox View

6 Comments

  • Log in to leave a comment
  • Profile image

    @deusalgor mhmm, good point.

    +1 5.3 years ago
  • Profile image
    872 deusalgor

    @AnotherFireFox, but if you need 270 degrees for example?

    +1 5.3 years ago
  • Profile image

    Actually you don't need that high range because setting it to 0 would give you unlimited range :P

    5.3 years ago
  • Profile image
    872 deusalgor

    @AndrewGarrison thanks!

    5.3 years ago
  • Profile image

    Also, great bug report! Thanks!

    +1 5.3 years ago
  • Profile image

    The large number you used was too large. I have updated the code to allow ranges beyond 180 degrees via XML modding.

    +1 5.3 years ago

No Upvotes

Log in in to upvote this post.