Crazybird C-525 Prototype

@Professorison it was actually kinda hard. So I use slider1 but I figured out how to make it so I don’t have to use slider1.
I used tinker panel and made new part of the wing called InputController which I put: -
inputId: Slider1
input: AG 5 (which was activation group for flaps)

@Crazyman552588 also how did you control the flaps with the activation groups?

@Professorison
Ok

@Crazyman552588 One: I’m now going to call you crazyman
Two: no I will not make another

@Professorison
One: I’m not your “boi”
Two: I meant make another plane with the nose you say that you can make under a minute.

@Crazyman552588 boi, all my plane noses were made in Under a minute, they were the smallest part of the planes build time, even smaller than the ENGINES

@Professorison make nose of plane. I don’t see

@Crazyman552588 look at any of my planes

@Professorison I wanna see.

@Professorison ok. Do it then.

@Crazyman552588 i can make a nose in like a minute

@Professorison i literally just figured out how to make a nose. It takes time and effort, especially to get the angles perfectly (without sticking out)

@Crazyman552588 boi, once you learn it’s easy

@Professorison ehh. Too much work, considering it was already super hard to get the current nose in the specific angle and everything

@Crazyman552588 I would recommend using different noses for different aircraft, that’s what I do

@Professorison I widened the nose of the C-300 series to go with the wider fuselage.

@PZLAgencies yes

@Crazyman552588 and I’m still at 500 since NO ONE likes my creations anymore

Have you been using the EXACT same nose from the C-300?

narrow body?

@Nksskssskss11 haha
I have plans for economy seats for the A-500 and A-525.

Airlines will love this by putting an ultra high density seats

Very cool

@JLaerospace yes, it will probably be based on the A350/B787.
And this is indeed based on the a321.

Will you make a widebody jet sometime later maybe?