- In craft designer create new craft.
- Add structural panel on top of command disk.
- Go to Part Rotate Tool.
- Click on "<" or ">" buttons next to X axis repeatedly till the angle reaches 90 or -90 degrees.
- On the next click it will jump back to 75 degrees and Y/Z will change to 180. Repeated clicks will keep jumping back and forth between 75 and 90.
- Bonus points. After step 5 if you use arrow buttons to rotate along Y or Z axes you will see that both of them rotate part around one same axis.
Bug
Active
Found in 1.0.4.0
| View |
No Comments
No Upvotes
Log in in to upvote this post.